[T6-7] Reaver (Build Guide)

Overview

A very simple guide on how to build my very own T6-7 Reaver Aircraft. The Reaver is a very effective stealth aircraft that can wreak havoc upon unsuspecting enemies as a very powerful air superiority fighter.

Preview

This is what the finished product should look like.

Getting Started (Part 1)

Before we begin getting into details we should start off with the basics.
-Each block has a colour code that goes as the following:
White = Full Block
T1 Bronze = Half Block (Prism Block)
T2 Green = Tetra Block
Grey = Inner Block

Now with that in mind, let’s make the base structure.
16 Full Blocks in length will make the base “rod” of the Bot.

Now adding in some 2D Details you get one layer of the bot complete, In the next 3 sections we will be going into detail on the Tail, Middle and Nose of the Reaver.

NOTE: The window Blocks signify the beginning and end of the base “rod” as well as where the Pilot seat is.

The Tail (Part 2)

Here we take a special look at the simplest part of the Reaver, It’s tail.

Start off by adding 7 Full blocks under the 7 in the rear of the Bot.
Following that, add Half blocks as seen in the picture. (Same on both sides)

Next comes the last part of the Tail.
One block from the rear add a Half block followed by 2 whole blocks ending in another half block, this is where your aerofoil and rudder will go.

Next we’re going to be making the back of the cockpit which is just 3 Inner blocks surrounded by Tetra blocks on each side. Seperating the two sides is one full block with a Half block on top and behind it.

Middle (Part 3)

In this section we cover the Cockpit and the belly of the Reaver.

In the middle of the bot we start off by finishing the cockpit with some Half and Full blocks.
Following that we finish up the cockpit with some asthetic adjustments to the front end of the cockpit.

To finish off the top of the Middle we add a little “Spout” that will be used later for the nose.

And thus finishes the top of the middle, now onto the tricky part, the belly.

Start off with a simple layer of blocks that we will begin to carve out and add to.

Add these pretty things under the original layer of the belly.

Finally moving on to the front of the belly we have a very tricky part that goes as following.
Please remember to remove the blocks from before to made the heart shaped underbelly.

To conclude the belly we add to its rear, bridging it with the tail.

Nose (Part 4)

Finally to conclude the construction of the Reaver we add another layer to the nose of the Bot.

Doing moreso to pretty it up, we add little spikes to the front, purely for asthetics.

And so concludes the building of the Reaver.

Equipment (Part 5)

Here I will show you where I recommend you put things like thrusters, Areofoils, Rudders and SMG’s.

Starting off with thrusters on the front provide vertical thrust vital for flight.

Moving on to adding in your first aerofoils in the middle and tail PLUS main forward thrusters.

Here shows my placement for both rudders and the second set if tail wings.

Here are the places I put my SMG’s.

Thank you!

Thanks for reading my guide, if you have any questions please feel free to ask and if you thought my guide was helpful or you really like the design please give me a thumbs up, thanks!