Overview
Learn to make an easy to use buggy! The one showcased is for tier 4, but it can be upgraded to go higher.
Needed Materials
For this buggy, you will need:
13 x T5 armor blocks (or any type, really)
2 x T4 railguns
3 x T4 jets
2 x T2 jets
4 x T5/6 wheels
You won’t need the alignment rectifier, as the T2 jets will be able to flip you over. the T4 jets will funtion as downforce allowing you to climb walls.
Construction
First, place 5 of your blocks in an upside-down U formation, then place five more coming off the center block in a straight line.
Then, place your wheels on the chasses like this:
You’ll notice that the front wheels are higher up than the back ones. This should happen, as it allows foward thrusters to act as downforce aswell.
Next, place your pilot seat and remaining 3 armored blocks at the back. this gives you the mount for a
railgun. After this, place your two T2 jets at the front. this will give you extra downforce when you need it, and the ability to flip back over.
Next, place your 3 T4 jets at the back, two on top, one underneath.
Finally, Place your railguns on, one ontop of the tower you built earlier, one on the block at the very front.
And you’re done! You can place a radar jammer on the bottom if you want.
Gameplay
This plays about the same as any other wall-climbing buggy. It’s very fragile, so you’ll want to stay away from close combat. I’ve found the most effective use of this is picking off weakened enemies and anti-air. Don’t expect to carry the team going into this vehicle, it’s entirely a support buggy.
Pros/Cons
Pros:
Great at anti-air and general sniping
Moderately fast, and very mobile because of the ability to wall climb
Has upgrade potental
High damage per hit
Cons:
Very fragile, not something to get even remotely close to the enemy with
Has a tendancy to flip easily
Low DPS
Hope you enjoy, and see you on the battlefield. unless you’re in this. I better not see you in this, you better be hiding and sniping in this.