Building the T7 Heavy Plasma Bomber

Overview

This guide will provide a text and screenshot based walkthrough showing you how to build a T7 Heavy Plasma Bomber, I have had great success with this design.

Materials and Cost

Required Materials;

Armored Cube T7: 146
Armored Prism T7: 124
Armored Tetra T7: 14
Thruster T3: 1
Thruster T5: 4
Thruster T6: 5
Thruster T7: 2
Radar Jammer T5: 1
Aerofoil T6: 4
Rudder T6: 3
Plasma Launcher T8: 6
Pilot Seat: 1

Associated Cost;

CPU: 820
Total RP: 883,973

Building the Frame

Step 1
Begin with a 3×12 frame of T7 Cubes;

Step 2
Add an additional row of T7 Cubes / T7 Prisms as shown below;

Step 3
Place a row of T7 Cubes on either side, one layer down, as shown below;

Step 4
Place six T6 cubes on either end, this will form a 3×3 block as shown below;

Step 5
Place a row of T7 Prisms, one layer down, as shown below;

Step 6
Add a T5 Radar Jammer on the upper inside of the vehicle, as shown below;

Step 7
Close the botton of the vehicle using T7 Cubes, as shown below;

Step 8
Add the platforms which will sit below the wings. These consist of T7 Prisms, T7 Tetras, and T7 Cubes as shown in the two screenshots below;

The frame is now complete, it should look as follows;

Add Aerofoils and Rudders

Add T6 Aerofoils and Rudders as shown below;

Attach Plasma Launchers

Attach the six T8 Plasma Launchers as shown in the screenshots below (The wings should mirror each other);

Place Thrusters

Attach four T6 Thrusters facing forward, the two shown in the screenshot below should be mirrored on the other side of the vehicle;

Attach two T7 Thrusters facing forward, the one shown in the screenshot below should be mirrored on the other side of the vehicle;

Attach two T5 Thrusters (Rear) and one T6 Thruster (Front) to the top of the vehicle, all facing forward, as shown below;

Attach two T5 Thrusters to the front of the vehicle, one facing upwards and the other downwards, as shown below;

Attach a single T3 Thruster facing upwards on the back panel, as shown below;

Final Results

Congratulations, you have completed the build! The final results should look as follows;

If used correctly, this vehicle is capable of an extremely accurate burst from high altitude. I took this screenshot of a burst from near the map ceiling, notice they are nearly on top of each other;

In order to achieve the best results ensure you are flying level, additionally try and keep the crosshair lined up for a second before you fire to ensure the guns have fully rotated into position.

I welcome comments and questions, please leave them below!

Robocraft Guide